. ATTACHMENTS, OPTIONS HYDRAULIC SECONDARY CONVEYOR TROUBLES AND CORRECTIVE ACTIONS 6 - 47 Problem Main causes Remedy Conveyor belt Not operable Electric circuit fault:
Electric failure in section from switch to solenoid valve Relief valve fault Defective coupler connection Emergency stop switch is ON Correct wiring or relay connections Measure hydraulic oil pressure Fit correctly in connecting portion Turn emergency stop switch OFF Snaky movement Misalignment of rollers and improper mounting Debris transport direction Debris stuck to rollers (Likewise wire or string winding about rollers) Belt elongation Belt bending, or not installed properly in endless processing Frame twisting and bending Frame not poised evenly (Belt is deflected to lower side) Belt too rigid (Wrong belt chosen) Adjust roller mounting angle Load debris evenly in the middle of the belt, after making sure that the machine is kept level on the ground Clean roller periphery Adjust belt tension with take-up Retry endless processing, or replace belt with new one Correct twisting and eccentricity at time of assembly or machine installation Correct twisting and eccentricity at time of assembly or machine installation a.
Run in belt without load b. replace with softer (proper) belt Abnormal wear on backside Slip on motor pulley (or driving pulley) surface Debris or foreign object stuck in between belt and pulley (Foreign objects stuck on pulley surface) Faulty rotation of rollers Correct belt elongation with take-up a. Remove foreign objects (Remove sticking) b. Improve loading conditions at loading part Replace faulty rollers