. OPERATION EXPLANATION OF COMPONENTS METER PORTION 3 - 19 ENGINE COOLANT TEMPERATURE GAU GE t temperature. e in black range (A) to (C). (B) during operation, the . s follows. temperature monitor (1) s set to low idling, engine r lamp (C) lights up red, e time, the alarm buzzer , and all work equipment the horn, turn the fuel e low idling position. until the temperature enters the black range (A) to (C). This mete r (5) show s the engine coolan During op If the indi eration, th cator ente e indicator should b rs red range (A) to e in black range (A) to (B) during operation, (C). the overheat prevention system is actuated . s follows.
temperature monitor (1) s set to low idling, engine The overh eat prevention system acts a Red range (A) position: Engine coolant lights up red. Red range (B) position: Engine speed i coolant monito and at the sam and horn sound stops. To stop control dial to th r lamp (C) lights up red, e time, the alarm buzzer , and all work equipment the horn, turn the e low idling position. fuel The overh eat prevention system works until the temperature enters the black range (A) When the engine is s tarted, if the indicat or is at position (C), engine coolant temperature m onitor (1) lights u p white. In this ca se, carry out the warming-u 3-76)". p operation.
For details, see "WARMING-UP OPERATION IN COLD WEATHE R (PAGE FUEL GAU GE This mete r (6) show s the amount of fuel remaining in the fuel t ank. The indic ator should be in the black ran ge during operation. ) during operation, the If the in dicator en ters red range (A remaining amount o f fuel is less than 6 0 liters (15.85 US gal) , so check and add fuel. REMARK If the indic ator enter s red range (B), the remaining amount of fuel is less tha n 41 liters (10.83 US gal). When the indicator i s in red range (A) to (B), fuel level monito r (1) lights up r ed. If the indic ator enter s the red range (A) t o (B), do not carry out operations on steep slope s.
There is dange r of the engine st alling. The corre ct fuel leve l may not be display ed for a short time when the starting switch is tur ned ON, but this is not an abnormali ty.