Komatsu — MACHINE MONITOR

. OPERATION EXPLANATION OF COMPONENTS engine speed. 3 - 20 HYDRAULIC OIL TEMPERATURE GAUGE ulic oil temperature. This meter (7) shows the hydra During operation, the indicator s hould be in black range (A) to (C). If the indicator enters red range (A) during operation, the hydraulic oil temperature is more than 102 °C (215.6 °F). Run the engine at low idling or stop it and wait until the hydraulic oil temperature goes down. REMARK The hydraulic oil temperature w hen the indicator enters red range (A) is as follows. an 102 °C (215.6 °F) draulic oil temperature monitor p red. an 105 °C (221 °F) draulic oil temperature monitor Red range (A) position:

More th The hy lights u Red range (B) position: More th The hy lights u at the s If the indicator is at position (C p red and the alarm buzzer sounds ame time. ) when the engine is started, the hydraulic oil temperature is less than 25 °C (77 °F) and hydraulic oil temperature monitor (1) ligh ts up white. When this happens, see "WARMING-UP OPERATI ON IN COLD WEATHER (PAGE g-up operation. 3-76)" and carry out the warmin SERVICE METER This monitor (8) shows the total hours of operation of the machine. Use the time display to set th e periodic maintenance intervals.

When the starting switch is at t he ON position, the service meter advances even if the machine i meter advances by 1 for every h s not moving. The reading of the our of operation, regardless of the CRUSHER ACTUAL CLEARANC E MONITOR This monitor (9) displays the cle the crusher jaw and fixed teeth arance at the discharge port when are fully opened (OSS clearance). REMARK This clearance display is sh own in black between 50 mm and 150 mm (2 in and 5.9 in), an it is displayed in red. Carry o the OSS clearance between in) (black display). The display value for the cle measured value.

d when it goes outside this range, ut actual crushing operations with 50 mm and 150 mm (2 in and 5.9 arance may not match the actual