USING THE MACHINE AS A LOADER 3.12.2.2 LOADING OPERATIONS ON SLOPES q Travel uphill with the bucket directed forward; the same rule must be followed when loading. q Travel downhill in reverse with the loader directed forward and lowered bucket. q Move changing direction very slowly, with the bucket as low as possible. q Avoid any transverse position with respect to the slope directrix. q Sudden movements of the bucket and dangerous positions may cause the machine to overturn and lead to serious accidents and even death. 3.12.3 CHANGING THE STANDARD FRONT BUCKET 1 3 q When the coupling pins are removed or installed, chips may come off; always use gloves, goggles and helmet.
2 q The change of the equipment must be carried out by two operators, who must decide together the words and signals to be used during work. q Avoid using your fingers to align the holes, since the may be injured or even cut off. RWA03660 q The described procedures are valid also for the coupling of the mechanical connections of the optional equipment. 1 - Position the bucket on level ground. 2 - Remove the check bolts (1) and the coupling pins (2). 3 - Change the bucket (3), taking care to clean the pins and bushings perfectly and to grease the pins slightly before reinstalling them. 4 - Put back the check bolts and tighten them. 5 - Lubricate the pins (see "4.5.1 LUBRICATION DIAGRAM".
NOTE q If the machine is equipped with front quick coupling, see "6.2 FRONT EQUIPMENT QUICK COUPLING DEVICES". 151 WARNING WARNING