USING THE MACHINE AS AN EXCAVATOR 3.13.3 SLIDING THE BACKHOE UNIT SIDEWARDS IMPORTANT q Before moving the backhoe unit, make sure that the sliding guides are clean and lubricated with grease. 1 - Release the front loader control and the backhoe control levers. 2 - Lower the stabilizers (1) to avoid overloading the rear wheels and to prevent the machine from oscillating. 3 - Swing the boom (2) against the machine. 4 - Manoeuvre the bucket (3) and the arm (4) until the bucket teeth are perpendicular to the ground when arm and boom form an angle of approx. 90°; plant the bucket teeth onto the ground. 5 - Release the backhoe unit (see "3.3.6 pos. 9 - BACKHOE SLIDING LOCK SWITCH").
6 - Make the unit slide by manoeuvring the arm. q Carry out this manoeuvre by operating the arm opening/folding lever smoothly, in such a way as to maintain the sliding support in vertical position and therefore facilitate the sliding movement. 7 - Lock the unit. 154 C AUTION