LONG PERIODS OF INACTIVITY 3.14 LONG PERIODS OF INACTIVITY 3.14.1 PREPARING THE MACHINE FOR A LONG PERIOD OF INACTIVITY q When draining the fuel, do not smoke, nor use naked flames near the machine. Place a container under the machine to gather the fuel and prevent it from spreading around. If some fuel should be spilled, clean the dirty area immediately. IMPORTANT q To protect the cylinder rods when the machine is not used, position the work equipment as shown in the figure. (This serves to prevent the cylinder rods from rusting).
NOTE q This preliminary operations must be carried out when the machine is going to remain unused for approximately 1 month; if the period of inactivity is expected to be longer, see also "3.14.2 PREPARING THE ENGINE FOR A LONG PERIOD OF INACTIVITY". If the machine is going to remain unused for a long period, to keep its components in good conditions it is advisable to store it in a sheltered place and to take the following measures: 1 - Clean the inside and the outside of the machine completely and very carefully, retouching any scratch on the paintwork in order to avoid oxidation.
2 - Drain and change all the fluids of the hydraulic circuits and the lubricants (axles, reduction gears, converter), following the indications given in the maintenance instructions. 4 - To prevent the deformation of the tyre sidewalls, insert supports or blocks under the axles, to nullify the weight of the machine. 3 - Change all the filtering elements (air filter, engine oil filter, hydraulic circuit filters, fuel filter). 5 - Grease the exposed rods of the hydraulic cylinders and the equipment joints. 6 - Shift the machine controls to the neutral position and engage the safety locks. 7 - Seal the end of the exhaust pipe and the engine breather outlets. 8 - Refuel completely.
9 - Remove the battery, check the electrolyte level and make sure that the battery is charged. Place the battery in a room with suitable temperature and recharge it periodically. 10 - Lock the cab doors, the filler cap and the engine hood. 11 - Seal the filler cap. 157 WARNING