Komatsu — 3.13.4.1 CHANGING THE BACKHOE BUCKET

USING THE MACHINE AS AN EXCAVATOR 3.13.4.1 CHANGING THE BACKHOE BUCKET 2 q When the coupling pins are removed or installed, chips may come off; always use gloves, goggles and helmet. 1 q The change of the equipment must be carried out by two operators, who must decide together the words and signals to be used during work. 3 3 q Avoid using your fingers to align the holes, since the may be injured or even cut off. RWA03670 q The described procedures are valid also for the coupling of the mechanical connections of the optional equipment. 1 - Position the bucket on level ground, directing it so that the flat part of the bucket back rests on the ground.

2 - Remove first the tie-rod pin (1) and then the arm connection pin (2). 3 - Change the bucket, taking care to clean the pins and bushings perfectly and to grease the pins slightly before reinstalling them. IMPORTANT q Install the arm connection pin first. 4 - Put back the safety retainers (3) of the pins. 5 - Lubricate the pins by means of the special grease nipple (see "4.5.1 LUBRICATION DIAGRAM"). NOTE q If the backhoe is equipped with quick coupling device, see "6.12 REAR EQUIPMENT MECHANICAL QUICK COUPLING DEVICE". 156 WARNING