Komatsu — 4.4.1 STANDARD DRIVING TORQUES FOR SCREWS AND NUTS

DRIVING TORQUES 4.4 DRIVING TORQUES 4.4.1 STANDARD DRIVING TORQUES FOR SCREWS AND NUTS q If screws, nuts or other parts are not tightened with the required torque, they may become loose or damage the components with which they cooperate, and this may cause machine failures or operation problems. Always pay the utmost attention when carrying out tightening operations. If not specified otherwise, tighten screws and nuts with the torque indicated in the table. If it is necessary to replace a screw or a nut, always use Komatsu original spare parts of the same size as those to be replaced. a Nm (Newton metre):

1 Nm = 0.102 Kgm IMPORTANTE q This driving torque table is not valid for screws or nuts that must fasten parts made of nylon or similar materials onto washers or components made of nylon or nonferrous metals or requiring specific driving torques.

177 ATTENZIONE Threaddiamete r (a) (mm) Pitch (mm) Wrench size (b) (mm) 8.8 10.9 kgm Nm kgm Nm 6 8 10 12 14 1 1,25 1,5 1,75 2 10 13 17 19 22 0,96 ± 0,1 2,3 ± 0,2 4,6 ± 0,5 7,8 ± 0,8 12,5 ± 1 9,5 ± 1 1,3 23 ± 2 3,2 45 ± 4,9 6,5 77 ± 8 1 122 ± 13 17 ± 0,15 13,5 ± 1,5 ± 0,3 32,2 ± 3,5 ± 0,6 63 ± 6,5 1 ± 1 108 ± 11 ,5 ± 2 172 ± 18 16 18 20 22 24 2 2,5 2,5 2,5 3 24 27 30 32 36 19,5 ± 2 27 ± 3 38 ± 4 52 ± 6 66 ± 7 191 ± 21 2 262 ± 28 3 372 ± 40 5 511 ± 57 7 644 ± 70 92 7 ± 3 268 ± 29 7 ± 4 366 ± 36 3 ± 6 524 ± 57 3 ± 8 719 ± 80 ± 10 905 ± 98 27 30 33 36 39 3 3,5 3,5 4 4 41 46 50 55 60 96 ± 10 131 ± 14 177 ± 20 230 ± 25 295 ± 33 945 ± 100 13 1287 ± 140 18 1740 ± 200 25 2250 ± 250 32 2900 ± 330 41 5 ± 15 1329 ± 140 4 ± 20 1810 ± 190 0 ± 27 2455 ± 270 0 ± 35 3150 ± 350 0 ± 45 4050 ± 450