MAINTENANCE PROCEDURES 4.8.1.h BLEEDING THE BRAKING CIRCUIT q Oil spilled on the floor may cause the floor to become slippery; immediately clean any dirty area. q The braking system must be bled with the machine positioned on level ground, the loader arm completely lowered, the backhoe boom in transport position and the parking brake applied. q Oils, filters, the coolant and the battery are considered special waste and must be collected and disposed of according to the regulations in force. This operation is important, since it ensures the braking efficiency and power of the machine. Proceed as follows: 1 - Disconnect the brake pedals, so that they are independent of each other.
2 - Apply a small pipe for the collection of the oil to the drain screws (1). 3 - Remove the front guard (2) and the cap (3) from the reservoir (4). 4 - Make sure that the oil in the braking system reaches the maximum level. 5 - Press the left brake pedal thoroughly and, keeping it pressed, loosen the drain screw (1) of the corresponding brake until the pedal reaches the end of stroke. Use a 13 mm wrench. 6 - While keeping the pedal completely pressed, tighten the drain screw (1). 7 - Release the brake pedal, wait a few seconds and repeat the operations described above until no air bubbles can be noticed in the oil that flows out of the drain screw (1).
8 - Carry out the same operations for the right pedal. 9 - After bleeding the circuit, start the machine and check the braking efficiency; if necessary, bleed the circuit again. 10 - Put back the front guard (2). IMPORTANTE q When bleeding the system, apply a small pipe to the screws (1), in order to collect the oil. q The bleeding procedure must be carried out for both braking units, disconnecting the pedals from each other. q Frequently check the oil level in the braking system and top up whenever the oil is near the minimum level. q To top up, use only new oil of the prescribed type. 195 AVVERTENZA