MAINTENANCE PROCEDURES 4.8.1.i CHECKING AND ADJUSTING THE WHEEL TOE-IN This check must be carried out according to time intervals fixed by the operator, since any anomaly regarding the wheel toe-in is due to impacts or vibrations that depend on the type of surface on which the machine works. Another reason that should lead the operator to perform this check is the excessive wear of the front tyres. The machine has been designed with a toe-in equal to 0 mm. Every adjustment must restore this value and must be carried out on the coupling bars (1) after loosening the nuts (2) that lock them. (Use 36 and 27 mm wrenches).
During this check and the relevant adjustment, it is advisable to check also the conditions of the articulated heads (3); if a considerable slack is observed, change them immediately. 3 1 2 RWA02980 4.8.1.j CHECKING THE BRAKING EFFICIENCY IMPORTANTE q During running-in, check the braking efficiency after the first 100 hours of operation. 2 q Perform this check on firm, level ground, with no people or obstacles around. This check must be carried out after setting the work equipment in the travel or transport position and engaging all the safety locks. 1 - Connect the brake pedals (2) with the pin (1). 1 2 - Release the parking brake and start the engine (see "3.6.2 STARTING THE ENGINE").
RWA13970 3 - Engage the 2 nd speed and the forward gear. 4 - Accelerate until reaching the maximum speed. 5 - Press the brake pedals. The machine must brake smoothly, on a straight line, and the tension of the pedals must be constant. Otherwise, contact your Komatsu Dealer. 196