MAINTENANCE PROCEDURES 4.8.1.k CHECKING AND ADJUSTING THE PARKING BRAKE IMPORTANTE q During running-in, check the efficiency of the parking brake after the first 100 hours of operation. CHECK Check conditions * +,- q Tyre pressure in accordance with the prescribed values. q Road surface dry, compact, with a gradient of approx. 20% (11°20’). ' ) q Machine in operating conditions without load. 1 - Start the engine (see "3.6.2 STARTING THE ENGINE"). 2 - Align the machine in travel position on a straight road section and proceed up the slope with 20% gradient. 3 - Stop the machine with the service brake, shift the reverse gear lever (1) to the neutral position (N) and stop the engine.
4 - Apply the parking brake (lock position), release the service brake slowly and make sure that the machine does not move. ADJUSTMENT 1 - With the engine off, release the brake lever and rotate the lever end (2) by giving it 2 or 3 counterclockwise turns. * +,- ' ) 2 - Start the engine, apply the parking brake and check again. 197