Komatsu — 4.8.1.m ADJUSTING THE AUTOMATIC RETURN- TO-DIG DEVICE OF THE FRONT BUCKET (if installed)

MAINTENANCE PROCEDURES 4.8.1.l CHECKING AND ADJUSTING THE BRAKE PEDAL STROKE This check must be carried out when operating on the braking unit in order to eliminate any trouble. To check and adjust the brake pedal stroke, proceed as follows: 1 - Insert the connection pin (1) in order to couple the pedals. 2 - By acting on the end-of-stroke rubber pads (2), position the pedals in correspondence with measure “A” - 313 mm; lock the pads in this position. (Use a 13 mm wrench). 1 3 - Lower the pedals to measure “A”-303 mm and adjust the brake pump rods (3) until they touch the brake pump pistons; lock them in this position. (Use a 22 mm wrench).

RWA13980 2 3 RWA38040 A RWA16470 4.8.1.m ADJUSTING THE AUTOMATIC RETURN- TO-DIG DEVICE OF THE FRONT BUCKET (if installed) (0.078-0.157 in) The device for the automatic return of the front bucket to the digging position automatically brings the front bucket to the loading position when it is lowered to the ground. The sensor is positioned on the right dumping cylinder and determines the horizontal position of the bucket, parallel to the ground, after the bucket dumping control has reached the end of stroke and the electromagnet of the distributor rod has been activated (see "3.3.6 pos. 4 - FRONT LOADER CONTROL LEVER").

The sensor must be positioned at a distance of 2-4 mm (0.078- 0.157 inches) from the sliding rod. RWA34420 198