MAINTENANCE PROCEDURES 4.8.1.n CHECKING AND ADJUSTING THE STABILIZER SLACK q When leaving the operator’s seat during the adjustment of the guides, remove the ignition key. 1 - Position the machine on level ground, raise the stabilizers completely, engage all the safety locks and stop the engine. 2 - Push and pull each stabilizer manually and make sure that the slack between the mobile rod (1) and the adjusting element (2) is included between 0.5 and 1.0 mm. If the slack exceeds the values indicated, loosen the screws (3), remove the adjusting plate (4) and remove one or more washers (5) from both the adjusting points, according to the needs.
Once they have been removed, the washers (5) must be positioned again between the adjusting plate (4) and the screws (3). During the adjustment, check the condition of the adjusting element (2) and change it immediately if it is excessively worn. After reassembling the washers (5), plate (4) and fastening screws (3) in this order, check if the slack is within the prescribed values. 3 3 4 5 5 2 1 RWA17270 199 AVVERTENZA