MAINTENANCE PROCEDURES 4.8.6.d LUBRICATING THE PROPELLER SHAFTS q Carry out this operation with the machine parked on a level surface, the work equipment resting on the ground and the engine off. The propeller shafts must be lubricated after thoroughly cleaning the grease nipples, by applying the grease pump filled with the prescribed grease. (See "4.3 FUEL, COOLANT AND LUBRICANTS" and "4.5.1 LUBRICATION DIAGRAM"). Once the lubrication procedure has been carried out, make sure that all the points have been lubricated and remove the used grease that may have spread out of the joints.
# IMPORTANTE q If the machine is used in difficult conditions, carry out this operation more frequently than usual. 207 AVVERTENZA