MAINTENANCE PROCEDURES 4.8.8.c CHECKING THE BATTERY ELECTROLYTE LEVEL q Carry out this check with the machine parked on level ground. q Check the level only after stopping the engine and if necessary add distilled water only before starting work. q Always wear safety goggles and waterproof gloves. q To prevent gas explosions, do not use naked flames, do not smoke and avoid producing sparks due to short circuits. q The battery electrolyte is dangerous; in case of contact with the eyes or skin, rinse with plenty of water and consult a doctor without delay. To reach the battery (1), release the lock (2), loosen the screws (3) and remove the upper cover (4). Use a 17 mm hex wrench.
The electrolyte level in each cell must be about 6 mm above the plate edge; if necessary, remove the cell caps and top up using exclusively distilled water. If, on the contrary, the level is low because some fluid has been spilled, add electrolyte with concentration suitable for the ambient temperature (see "3.10.3 BATTERY"). NOTA q When adding distilled water or electrolyte, do not exceed the level indicated. This would shorten the service life of the battery and may cause the electrolyte to overflow. Put back the upper cover (4) and lock the door (5). IMPORTANTE q It is advisable to add distilled water before starting work, in order to prevent if from freezing.
q Before putting back the cell caps, make sure that the breather holes are not clogged. q Make sure that the terminals and connection cables are not oxidized; if necessary, clean them and cover them with anti-oxidation grease. 212 AVVERTENZA