MAINTENANCE PROCEDURES 4.8.8.d CHECKING THE FRONT AXLE OIL LEVELS q Carry out this check with the machine parked on a level surface and the work equipment resting on the ground. DIFFERENTIAL This check is visual and serves to verify if the lubricant reaches the hole (1); if necessary, top up using the prescribed oil (see "4.3 FUEL, COOLANT AND LUBRICANTS"). The level hole (1) must be used also as filling hole. Use a 1/2” square wrench. FINAL REDUCTION GEARS This check must be carried out on each reduction gear positioned with its plug on the horizontal axis. If necessary, move the machine slightly until reaching the specified position, which is indispensable for an accurate check.
This a visual check and serves to verify if the lubricant reaches the hole (2); if necessary, top up using the prescribed oil (see "4.3 FUEL, COOLANT AND LUBRICANTS"). Use a 17 mm wrench. 4.8.8.e CHECKING THE REAR AXLE OIL LEVEL q Carry out this check with the machine parked on a level surface and the work equipment resting on the ground. DIFFERENTIAL This check is visual and serves to verify if the lubricant reaches the hole (1); if necessary, top up using the prescribed oil (see "4.3 FUEL, COOLANT AND LUBRICANTS"). The level hole (1) must be used also as filling hole. (Use a 17 mm wrench).
FINAL REDUCTION GEARS This check must be carried out on each reduction gear positioned with its plug on the horizontal axis. If necessary, move the machine slightly until reaching the specified position, which is indispensable for an accurate check. This a visual check and serves to verify if the lubricant reaches the hole (2); if necessary, top up using the prescribed oil (see "4.3 FUEL, COOLANT AND LUBRICANTS"). Use a 17 mm wrench. 213 AVVERTENZA AVVERTENZA