MAINTENANCE PROCEDURES 4.8.11.b CHANGING THE REAR AXLE OIL q Change the oil with the machine parked on a level surface and the work equipment resting on the ground. q Oils, filters, the coolant and the battery are considered special waste and must be collected and disposed of according to the regulations in force. q On new machines change the front axle oil after the first 250 hours of operation and successively every 1000 hours. This operation must be carried out with the machine positioned on level ground and at operating temperature, so that the oil becomes fluid and can easily be drained, which facilitates the elimination of any suspended solid particles.
DIFFERENTIAL 1 - Remove the drain plug (2) of the central body and let the used oil flow out completely, gathering it into a container with suitable capacity. While the oil flows out, remove the level plug (1). (Use a 1/2” square wrench and a 17 mm hex wrench). 2 - Once the oil has been drained, put back the drain plug (2) and add oil of the prescribed type through the hole (1), until reaching the level corresponding to the lower edge of the hole itself. IMPORTANTE q With this operation both axle shafts are filled with oil; before checking the level definitively and putting back the plug, wait a few minutes, in order to allow the oil to be distributed uniformly. 3 - Put back the plug (1).
FINAL REDUCTION GEARS 1 - Move the machine until the plug (3) is in low position on the vertical axis. 2 - Remove the plug (3) and let the used oil flow out, gathering it into a container with suitable capacity. Use a 1/2” square wrench. 3 - Once the oil has been drained, move the machine until the plug (3), which serves also as level indicator, is positioned on the horizontal axis. 4 - Add oil of the prescribed type until reaching the lower edge of the hole itself. 5 - Put back the plug (3). Carry out some forward and backward movements, stop the machine and check the levels again. Always use oil of the prescribed type (see "4.3 FUEL, COOLANT AND LUBRICANTS"). 225 AVVERTENZA ATTENZIONE