Komatsu — 4.8.11.c CHANGING THE HYDRAULIC TRANSMISSION OIL

MAINTENANCE PROCEDURES 4.8.11.c CHANGING THE HYDRAULIC TRANSMISSION OIL q Change the oil with the machine parked on level ground and lifted loader arm with engaged safety lock. q The hydraulic transmission oil must be drained at operating temperature, which is very high, and may cause severe burns; wear insulating gloves, goggles and safety shoes. q Immediately clean any area dirty with oil. q Oils, filters, the coolant and the battery are considered special waste and must be collected and disposed of according to the regulations in force. q On new machines change the hydraulic transmission oil after the first 250 hours of operation and successively every 1000 hours.

When changing the transmission oil, change also the filter (see "4.8.11.d CHANGING THE HYDRAULIC TRANSMISSION OIL FILTER"). Proceed as follows: 1 - With the machine at operating temperature, stop the engine, open the engine hood (see "3.5.1 ENGINE HOOD") and extract the dipstick (2). 2 - Remove the drain plug (1) and let the oil flow into a container with suitable capacity. Use a 1/2” square wrench. 3 - Remove the filter (3) and change it (see "4.8.11.d CHANGING THE HYDRAULIC TRANSMISSION OIL FILTER"), paying the utmost attention. 4 - Put back the plug (1) and add oil until reaching the MIN. level on the dipstick (2).

5 - Start the engine and let it idle to fill the converter and the internal circuits. 6 - While the engine is idling, add oil until reaching the MIN. level again. 7 - When the oil reaches a temperature of approximately 50°C, add oil until reaching the MAX. mark. See "4.3 FUEL, COOLANT AND LUBRICANTS". 8 - Close the engine hood. 226 AVVERTENZA ATTENZIONE