Komatsu — 4.8.12.c CHANGING THE BRAKING SYSTEM OIL

MAINTENANCE PROCEDURES 4.8.12.c CHANGING THE BRAKING SYSTEM OIL q Oil spilled on the floor may cause the floor to become slippery; immediately clean any dirty area. q Oils, filters, the coolant and the battery are considered special waste and must be collected and disposed of according to the regulations in force. Before changing the braking system oil, it is advisable to brake a few times in order to warm up and fluidize the oil and therefore facilitate draining. The oil change and the bleeding of the braking system must be carried out with the machine positioned on level ground and parking brake applied. Drain the oil and wash the system, proceeding as follows:

1 - Apply a small pipe for the collection of the oil to the drain screws (1) and loosen them. Use a 13 mm wrench. 2 - Remove the front guard (2) and the cap (3). 3 - Operate the brake pedals (connected with each other) until the oil contained in the reservoir (3) runs out. 4 - Fill the reservoir (3) with new oil and keep pressing the pedal; repeat this operation more than once until the used oil (about 0.8 l) has been changed completely; bleed to release the residual air (see "4.8.1.h BLEEDING THE BRAKING CIRCUIT"). For details on the oil to be used, see "4.3 FUEL, COOLANT AND LUBRICANTS". 231 AVVERTENZA