Komatsu — 4.8.12.b CHANGING THE COOLANT

MAINTENANCE PROCEDURES 4.8.12.b CHANGING THE COOLANT q Change the coolant every 2000 hours of operation or every 2 years, whichever occurs first. q Soon after the machine has been stopped the coolant is very hot and under pressure and it may cause serious burns; let the engine cool down until it reaches approximately 40–45°C before changing the coolant. q Slowly loosen the radiator cap, in order to release any residual pressure. q Oils, filters, the coolant and the battery are considered special waste and must be collected and disposed of according to the regulations in force. IMPORTANTE q The change of the permanent coolant does not require any washing cycle to descale the circuit.

1 - Open the engine hood (see "3.5.1 ENGINE HOOD"). 2 - Loosen and remove the upper cap (1) of the radiator. 3 - Open the drain cock (2) of the radiator and let the fluid flow out, gathering it into a container with suitable capacity. Drain the expansion tank (3) while the fluid flows out. 4 - Close the drain cock (2) and fill the radiator with new fluid (see "4.3 FUEL, COOLANT AND LUBRICANTS"). 2 5 - Start the engine and let it run at accelerated idle speed for a few minutes; check the level again and top up before putting back the upper cap (1). 6 - Fill the expansion tank (3) until reaching the maximum level. 7 - Close the engine hood. RKA15480 .& & 230 ATTENZIONE AVVERTENZA 2