MAINTENANCE PROCEDURES 9 - Change the drain filter (see "4.8.10.c CHANGING THE HYDRAULIC SYSTEM OIL FILTER"). 10 - Put back the drain plugs (2) and (3) and fill the oil tank with the prescribed oil until reaching the correct level. 11 - Raise the front mat and remove the cover (9). 12 - Loosen the bleeder plug (10) positioned on the hydraulic pump, until no air bubbles can be observed in the oil that flows out (use a 19 mm hex wrench). Tighten the bleeder plug (10) and put back the cover (9). Use a 13 mm wrench. ! 13 - Put back the filler cap (1), start the engine and operate the machine making each piston move several times in order to bleed the system.
Stop the machine in maintenance position, check the oil level again and top up if necessary. Always use oil of the prescribed type (see "4.3 FUEL, COOLANT AND LUBRICANTS"). 14 - Close the engine hood. IMPORTANTE q Do not start the engine with empty tank, since this would certainly damage the pump. q In machines equipped with demolition hammer hydraulic oil deteriorates more rapidly than in machines used for simple digging operations. Perform the oil change according to the indications given in the table below. " Replacement interval for hydraulic oil 2000 Replacement interval (H) 1500 1000 500 0 20 40 60 80 100 Breaker operating ratio (%) RWA07630 229