Komatsu — 6.2.3 HYDRAULIC QUICK COUPLING FOR 4in1 BUCKET AND OPTIONAL EQUIPMENT WITH UNIDIRECTIONAL OIL FLOW

FRONT EQUIPMENT QUICK COUPLING DEVICES 6.2.2 HYDRAULIC QUICK COUPLING FOR STANDARD BUCKET The operations to be performed are those described in the previous paragraph (see "6.2.1 MANUAL QUICK COUPLING"), except for the backward movement and the engagement of the coupling pins, which are obtained by means of the push buttons (9) and (10) located on the lever (3). (See "3.3.6 pos. 12 - 4 IN1 BUCKET OPENING PUSH BUTTON" and pos. 13 - 4 IN1 BUCKET FOLDING PUSH BUTTON").

" 6.2.3 HYDRAULIC QUICK COUPLING FOR 4in1 BUCKET AND OPTIONAL EQUIPMENT WITH UNIDIRECTIONAL OIL FLOW q Before carrying out any operation on the hydraulic circuit, stop the engine and eliminate the residual pressure by proceeding as follows: 1 - Turn the ignition key to position « » . 2 - Press the servo control locking button and make sure that the LED is off (release position) (see "3.3.2 pos. 12 - SERVO CONTROL LOCKING BUTTON"). 3 - Operate the loader arm control lever and the 4in1 bucket opening and folding buttons more than once. 4 - Turn the ignition key to position « » ). q If any oil has been spilled, wipe it up immediately, in order to prevent the surface from getting slippery.

The 4 in1 bucket and the hydraulic equipment that can be installed on the machine must be provided with quick coupling devices. In this case, the backward movement and the engagement of the coupling pins are obtained by connecting the quick couplings (11- 12) of the 4in1 bucket (or other equipment) delivery and drain pipes to the quick coupling unit, with the engine at rest. RWA01960 RWA02000 248 WARNING