Komatsu — 6.3.3 INSTALLING THE 4in1 BUCKET

4in1 BUCKET 6.3.3 INSTALLING THE 4in1 BUCKET q When the coupling pins are removed or installed, chips may come off; always use gloves, goggles and helmet. q The change of the equipment must be carried out by two operators, who must decide together the words and signals to be used during work. q If any oil has been spilled, wipe it up immediately, in order to prevent the surface from getting slippery. q Avoid using your fingers to align the holes, since the may be injured or even cut off.

To install the 4in1 bucket it is necessary to engage the mechanical constraints of the loader as described in "3.12.3 CHANGING THE STANDARD FRONT BUCKET" and to carry out the hydraulic connections using the pipes provided. q After mechanically connecting the bucket to the loader arm, stop the engine, apply the parking brake and eliminate the residual pressure from the hydraulic circuits by proceeding as follows: 1 - Turn the ignition key to position « » . 2 - Press the servo control locking button and make sure that the LED is off (release position) (see "3.3.2 pos. 12 - SERVO CONTROL LOCKING BUTTON").

3 - Operate the loader arm control lever and the 4in1 bucket opening and folding buttons more than once. 4 - Turn the ignition key to position « » ). q When connecting the pipes, take care to prevent any impurities from getting into them. Proceed as follows: 1 - Loosen the protection plugs and remove them from the rigid pipes provided on the machine. 2 - Loosen and remove the protection plugs from the flexible pipes (8) and (9) of the bucket. 3 - Carry out the connections as indicated in the figure.

RWA01960 4 - Start the machine, lift the bucket a few centimeters from the ground and open and fold it completely more than once using the buttons positioned on the control lever, in order to check the efficiency and tightness of the system. RWA02000 250 WARNING CAUTION