CONFIGURATION FOR THE INSTALLATION OF THE DEMOLITION HAMMER 6.6.2 USE OF THE DEMOLITION HAMMER AND RULES TO BE OBSERVED The choice of the suitable tool is a very important factor when maximum productivity is required of the demolition hammer. The shape and size of the tool must be defined according to the nature of the material to be broken and to the type of work to be carried out. The hammer is used for the demolition of floors, concrete structures, walls, small rocky surfaces, open excavations, asphalt, etc. With the application of special tools it can also be used as asphalt-cutter or compactor. FOR A CORRECT USE OF THE HAMMER, IT IS NECESSARY TO:
1 - Make sure that the position of the hammer with respect to the material to be broken is as perpendicular as possible and that the arm thrust is sufficient, so that all the power of the hammer can be exploited. 90 ° 90 ° RWA06410 2 - Keep the pressure of the excavator on the hammer constant as the bit penetrates the material. Always follow the hammer while it penetrates and operate the excavator arms in order to obtain a pressure sufficient to keep the undercarriage raised approximately 5 cm from the ground. Do not raise the rear wheels more than necessary. 0& 3 - When working on very hard materials, it is important to avoid hitting the same point for more than 30 seconds.
Hit the same point just for a few seconds and change position very frequently, in such a way as to facilitate the breaking of the material. RWA06430 261