Komatsu — 6.6.3.1 INSTALLING THE HAMMER

CONFIGURATION FOR THE INSTALLATION OF THE DEMOLITION HAMMER 6.6.3 INSTALLING AND REMOVING THE DEMOLITION HAMMER 6.6.3.1 INSTALLING THE HAMMER q The machine must be parked on a level surface, with the front equipment resting on the ground. q For the installation, the hammer must be positioned horizontally, with the bit directed towards the machine. q When the coupling pins are removed or installed, chips may come off; always use gloves, goggles and helmet. q The change of the equipment must be carried out by two operators, who must decide together the words and signals to be used during work. q Avoid using your fingers to align the holes, since they may be injured or even cut off.

q Before carrying out any operation on the hydraulic circuit, eliminate the residual pressure from the equipment circuits by moving the controls more than once and from the tank by slowly loosening the filler cap. q If any oil has been spilled, wipe it up immediately, in order to prevent the surface from getting slippery. For the installation of the demolition hammer it is necessary to connect the mechanical constraints of the backhoe bucket as described in "3.13.4.1 CHANGING THE BACKHOE BUCKET" and to carry out the hydraulic connections using the pipes provided. After connecting the mechanical constraints, carry out the hydraulic connections by proceeding as follows:

1 - Stop the engine and move the hydraulic controls in all directions, in order to completely release the residual pressure present in the circuits of the machine. 2 - Press the hammer control pedal to release the pressure present in the hammer delivery pipe. RWA01960 IMPORTANT q If the machine is equipped with backhoe servo controls, to eliminate the residual pressure proceed as follows: 1 - With the engine at rest, turn the ignition key to position « » . 2 - Press the servo control locking button and make sure that the LED is off (release position) (see "3.3.2 pos. 12 - SERVO CONTROL LOCKING BUTTON"). 3 - Shift the backhoe control levers more than once and press the hammer control pedal.

4 - Turn the ignition key to position « » . RWA02000 265 WARNING