Komatsu — 6.8.3 MAINTENANCE

CONFIGURATION FOR THE USE OF OPTIONAL EQUIPMENT WITH UNIDIRECTIONAL OIL FLOW 6.8.2 INSTALLING AND CONNECTING THE EQUIPMENT The equipment must be installed following the procedure indicated in paragraph "3.13.4.1 CHANGING THE BACKHOE BUCKET". Connect the delivery and return pipes by proceeding as follows: 1 - After connecting the equipment, stop the engine and shift the hydraulic controls in all directions, in order to release the residual pressure from the machine circuits. IMPORTANT q If the machine is equipped with backhoe servo controls, to eliminate the residual pressure proceed as follows: 1 - With the engine at rest, turn the ignition key to position « » .

2 - Press the servo control locking button and make sure that the LED is off (release position) (see "3.3.2 pos. 12 - SERVO CONTROL LOCKING BUTTON"). 3 - Shift the backhoe control levers more than once and press the equipment controls. 4 - Turn the ignition key to position « » . q During the successive steps, take care to prevent any impurities from getting into the circuit. q If any oil has been spilled, wipe it up immediately, in order to prevent the surface from getting slippery. 2 - Remove the plugs of the two pipes and of the installed equipment. 3 - Connect the delivery and return pipes.

4 - Start the machine and carry out several manoeuvres with the pedal (1) or with the buttons (2-3) used to control the equipment, in order to verify the tightness of the circuits. q Wear thick gloves and safety goggles during this check. q To check the system for leaks, use a piece of cardboard or RWA01960 a wooden board. 5 - Stop the machine and if necessary fasten the longer pipes in order to avoid vibrations and therefore critical conditions for the coupling connections. 6.8.3 MAINTENANCE The hydraulic system does not require any maintenance operation and inspection other than those prescribed for the machine.

Regarding the maintenance operations required for the equipment, see the specific operation manuals. RWA02000 271 CAUTION WARNING