CONFIGURATION FOR THE USE OF THE HAND HYDRAULIC HAMMER 6.10.2.2REMOVING THE CONNECTIONS At the end of work, proceed as follows: 1 - Press the push button (4) to disconnect the circuit, reduce the engine rpm and stop the engine. 2 - Move the hydraulic controls more than once in all directions, in order to release any residual pressure from the circuits of the machine. 3 - Turn the ignition key to position « » and press the hammer control push button (4) to release the residual pressure from the hammer delivery pipe; after releasing the pressure, press the push button (4) again to disconnect the circuit. 4 - Turn the ignition key to position« ».
IMPORTANT q If the machine is equipped with backhoe servo controls, to release the residual pressure from the circuits follow the procedure indicated in the previous paragraph "6.10.2 INSTALLING AND REMOVING THE HAND HAMMER". 5 - Disconnect the hammer. q If quick couplings are not provided, place sealing plugs with the relevant gaskets on the couplings of the machine and of the hammer. q Make sure that the plugs are properly tightened and that there are no leakages; if the circuit is inadvertently pressurized, small leakages can be turned into thin jets that may perforate the skin or injure the eyes. q Always wear thick gloves and safety goggles to carry out this check.
q To check the system for leaks, use a piece of cardboard or a wooden board. 6.10.3 USING THE HAMMER Consult the specific manual. 6.10.4 MAINTENANCE The hydraulic system does not require any maintenance operation and inspection other than those prescribed for the machine. Regarding the maintenance operations required for the hammer, see the specific operation manual. 278 CAUTION WARNING