Komatsu — 6.10.2.1 CONNECTING THE HAND HAMMER

CONFIGURATION FOR THE USE OF THE HAND HYDRAULIC HAMMER 6.10.2 INSTALLING AND REMOVING THE HAND HAMMER q The connection and removal of the hammer must be carried out with the machine parked on a level surface and the equipment resting on the ground, parking brake applied and control safety locks engaged. q Completely release any residual pressure from the pipes before connecting or disconnecting the hammer. q If any oil has been spilled, wipe it up immediately, in order to prevent the surface from getting slippery. 6.10.2.1CONNECTING THE HAND HAMMER To connect the hammer, proceed as follows:

1 - Stop the engine and move the hydraulic controls in all directions, in order to completely release the residual pressure present in the circuits of the machine. 2 - Turn the ignition key to position « » and press the hammer control push button (4) to release the residual pressure from the hammer delivery pipe. 3 - Turn the ignition key to position « ». IMPORTANT q If the machine is equipped with backhoe servo controls, to eliminate the residual pressure proceed as follows: 1 - With the engine at rest, turn the ignition key to position « » . 2 - Press the servo control locking button and make sure that the LED is off (release position) (see "3.3.2 pos. 12 - SERVO CONTROL LOCKING BUTTON").

3 - Move the backhoe control levers more than once and press the hammer control button (4) to release the residual pressure from the hammer delivery pipe. 4 - Turn the ignition key to position « » . 4 - Make sure that the couplings are perfectly clean and connect the hammer. 5 - Start the engine and press the push button (4) to enable the hammer circuit. RWA01960 6 - Increase the engine speed to the rpm indicated in the technical data by means of the hand accelerator and then start working. RWA02000 277 WARNING