Chapter 7 TPD1317e (c) It is important to include the propeller shaft in the bonding system, as the electrical path through the gearbox is not effective due to the gearbox oil acting as an insulator. The electrical connection to the shaft may be made by means of graphite brushes riding on the shaft or a braided battery strap may be used as illustrated below. In either case the shaft earthing system should be connected to the bonding system to which the engine and the shaft log (if metal) are also connected. Note: Strap should make contact with 90 o of shaft circumference.
One way to earth the propeller shaft Connection to common bonding Battery earthing system strap Ahead (d) Before the boat enters service the effectiveness of the bonding and sacrificial Zinc anode system should be tested, both when at rest and with all systems (including engines) in operation, by a specialist in this field. Note: This section on bonding covers a typical system and has been included for guidance purposes only. It may not be appropriate for your boat. As installations vary it is advised that specific recommendations from a specialist in the subject of electrolytic corrosion are obtained. Page 54