Perkins — Perkins Sabre Marine Engines Installation Manual

TPD1317e Chapter 7 (b) Typical system in common use The bonding system in the boat should provide a low resistance connection between all metals in contact with sea water, together with a connection to a Zinc sacrificial anode which is fixed to the outside of the hull below sea level. The bonding should consist of heavy stranded wire (not braiding or wire with fine strands). It is an advantage if the wire is tinned. Insulation is also an advantage and should preferably be green in colour. Although the current carried by the bonding system will not normally exceed 1 amp, the cable sizes should be generous as shown in the table below:

As many of the connections may be splashed with sea water they should be soldered wherever possible and clamped elsewhere, with the joint protected from corrosion by neoprene paint, or a similar material, to exclude water. Page 53 Length of run to Zinc Anode Suggested cable size Up to 30 feet 30 - 40 feet 7 strand / 0.85mm (4mm2) 7 strand / 1.04mm (6mm2)