Perkins — Perkins Sabre Marine Engines Installation Manual

Chapter 7 TPD1317e (c) Grounding the battery negative It is recommended that the battery negative busbar should be grounded as close as possible to the battery, by a substantial connection to the bonding system within the boat. This will reduce the likelihood of interference between items of electrical and electronic equipment fitted to the boat. (d) Battery isolator switches A switch should be fitted in the positive lead to the starter, as close to the battery as is convenient. The switch should be suitable for a momentary current of at least 1000 Amps. 7.7 Zinc Anode bonding system Caution: The engine may be damaged by electrolytic corrosion if the correct bonding procedure is not adopted.

Please read the guidelines below carefully. (a) Electrolytic corrosion within the engine cooling system and transmission can be much reduced or eliminated by bonding the engine to a Zinc anode which is used to protect through the hull metal fittings and other metal components that are in contact with sea water. The engine is fitted with a stud that may be used for this purpose, see, ‘Location of engine installation points’ at the beginning of this manual, for location of the stud. The stud is identified by a label, shown below: BOATBUILDER Use this stud to connect the engine to the Zinc Anode system installed in the boat. (For further details see the Installation Manual) 7089-1-95 Page 52