TPD1317e Chapter 9 Provision for Power Take-off The ability to drive additional equipment from the crankshaft nose varies according to the engine model, as shown in the table below: Note: i) Maximum recommended offtake 2 kW per belt. ii) Multiple belt driven accessories should as far as possible be distributed evenly on either side of the engine to minimise side loads iii) Customers wanting to fit a non-standard drive pulley or coupling, should ensure the inertia of the added components does not exceed 0.0313 kg/m 2 . iv) If you are in any doubt, please contact your distributor.
Page 61 Engine Models Maximum PTO capability including both axial and belt drives Maximum belt drive power M92/M115T M130C/M135 Full engine power 6 kW M185 59 kW at up to ............. 1000 rev/min 79................................. 1200 73................................. 1400 60................................. 1600 70................................. 1800 79................................. 2000 89................................. 2200 98................................. 2400 103............................... 2500 6 kW M215C/M225Ti Full power at up to........ 1200 rev/min 80 kW........................... 1400 62................................. 1600 62.................................
1800 84................................. 2000 93................................. 2200 104............................... 2400 110................................ 2500 6 kW M265Ti 14 kW 8 kW at up to 2000 rev/min 5 kW above 2000 rev/min M300Ti 8 kW at up to 1800 rev/min 8 kW at up to 1800 rev/min Note: Above 1800 rev/min, no additional equipment should be driven by a M300Ti