Perkins — Perkins Sabre Marine Engines Installation Manual

Chapter 9 TPD1317e (a) For Axial Drives A Fenner F80 tyre type coupling should be used, and can be supplied with the engine. Flexible tyre Taper lock flanges Taper lock PTO shaft Figure 1 - The Fenner F80 coupling. (b) For Belt Drives Standard options are:- Either a Fenner 5” A section pulley with three grooves. or A Fenner 5” B section pulley with two grooves. In this case the maximum power which can be taken will be limited by the belts, and it will be necessary to calculate for marginal applications. Pulley Taper lock Figure 2 - The Fenner 5” A-section with Figure 3 - The Fenner 5” B-section three grooves. with two grooves. Caution: Additional inertia must not be added to the P.T.O.

shaft without specialist advice. Consult your distributor if you need advice about non-standard drive arrangements. Page 62