Operation 3.2 Explanation of components 14. Kickdown switch When the gearshift lever is in 2nd, if switch (14) on the head of the lift arm control lever is pressed, the transmission will shift down to 1st. Use this when you need to increase the drawbar pull in digging operations. When the gear shift lever is at F1 and the power mode selector switch is at E mode, if switch (14) is pressed, the mode will switch to P mode. GK038030 Use this function during scraping-up operations or during dig- ging operations when it is desired to further increase the lifting force. ! When using E mode 2nd (E mode) -> 1st (E mode) -> 1st (P mode) !
When using P mode 2nd (P mode) -> 1st (P mode) If the transmission is in auto-shift, and the travel speed is below 10.5 km/h (6,5 MPH) in any speed range when traveling in either forward or in reverse, the kick-down switch is actuated and it is possible to shift down to 1st. This makes it easy to carry out load and carry operations. Even if the travel speed is more than 10.5 km/h (6,5 MPH), this switch can be used to shift the transmission down. Each time the kick-down switch is pressed, the speed range will shift down one range at a time (F4 -> F3 -> F2). REMARK When canceling the kick-down, operate the directional lever.
In manual shift, the kick-down can be canceled by operating the gearshift lever to any position other than 2nd. It is also possible to cancel the kick-down by turning the starting switch OFF. In auto-shift, if the travel speed becomes high after the kick- down, the gear will be shifted up by the auto-shift. In auto-shift, when traveling at more than 18 km/h (11.2 MPH) in 3rd or at more than 28 km/h (17.4 MPH) in 4th, even if the kick- down switch is pressed, the transmission will not shift down. This is to prevent overrun of the engine. WA470-6H – VEAM946100 3-49