Komatsu — Walk-around check

3.3 Operation Operation 11. Check for damage to seat belt and mounting clamps. Check that there are no loose bolts on the equipment mount- ing the seat belt to the machine, and tighten if necessary. If the belt is damaged or fluff is starting to form, or if there is any damage or deformation of the seat belt holders, replace the seat belt. 12. Clean cab window. Clean the cab window to ensure good visibility when operat- ing the machine. 13. Check and cleaning of the rear view mirrors. Check the rear view mirrors for breakage, and replace any broken one. Clean the surface of each mirror and adjust the angle so that the rear view can be seen clearly from the operator's platform. 14.

Inspect tires. If worn or damaged tires are used, they may burst and cause serious injury or death. To ensure safety, do not use the following tires. Wear: Tires with a tread groove of less than 15% of that of a new tire Tires with extreme uneven wear or with stepped-type wear Damage: Tires with damage which has reached the cords, or with cracks in the rubber Tires with cut or pulled cords Tires with peeled (separated) surface Tires with damaged bead Leaking or improperly repaired tubeless tires Deteriorated, deformed or abnormally damaged tires which do not seem usable Cord Bead GK032176 15. Inspect rims. Check the rims (wheels) and rings for deformation, corrosion and cracks.

In particular, check the side rings, lock rings and rim flanges thoroughly. 3-90 WA470-6H – VEAM946100 GK015036 WARNING WARNING WARNING