3.3 Operation Operation If the steering wheel is operated and stopped while the oil tem- perature is low, there may be a time lag before the machine stops turning. In this case, use the frame lock bar to ensure safety, and per- form the warm-up operation in a wide place. Do not relieve the hydraulic oil in the circuit continuously for more than 5 seconds. GK047005 Free Lock NOTE Turn the steering wheel a little and stop in that position. Confirm that the machine turns by an angle equivalent to the amount that the steering wheel is turned. Select the oil from the table of recommended oils below accord- ing to the ambient temperature.
If KOMATSU EO10W30-DH is used in the cold season, replace it with KOMATSU EO15W40-DH oil when the cold season fin- ishes. 6. After carrying out the warming-up operation, check that the gauges and pilot lamps are normal. 2 5 If there is any abnormality, carry out maintenance or repair. Run the engine under a light load until engine cooling water temperature gauge (2) and torque converter oil temperature gauge (5) are in the green range. 7. Check that there is no abnormal exhaust gas color, noise or vibration. If any abnormality is found, contact your KOMATSU distributor.
GK038005 REMARK The rotating speed of the cooling fan differs according to the fol- lowing conditions, but this does not indicate any abnormality. The cooling fan speed increases when the hydraulic oil tempera- ture, engine coolant temperature, or transmission oil tempera- ture are high. However, when the cooling fan is rotating in reverse, it rotates at a fixed speed proportional to the engine speed, regardless of any oil or coolant temperature. 3-112 WA470-6H – VEAM946100 WARNING WARNING Reservoir Fluid Type Ambient Temperature -22 -4 14 32 50 68 86 104 122 °F -30 -20 -10 0 10 20 30 40 50 °C Hydraulic system Engine oil