Operation 3.3 Operation Locate the cause and do not operate the machine until it has been repaired. REMARK If any function of the oil pressure system is used when the engine is running at low speed, steering oil pressure caution lamp (red) (3) may light up for a moment, but if the lamp goes out again soon, there is no problem. When the emergency steering system detects that the oil pres- sure in the steering circuit has been restored, the actuation of the emergency steering system is stopped. On machines equipped with an emergency steering function, the emergency steering switch is installed at the position shown in the diagram (1).
Emergency steering self-check function When the starting switch is turned ON, the emergency steering is automatically actuated for approx. 3 seconds to check that the emergency steering is functioning properly. When this happens, steering oil pressure caution lamp (red) (1) and emergency steering pilot lamp (green) (2) light up. CAUTION ! If the machine is steered during the steering self-check, it may move. ! Do not steer the machine during the steering self-check. GK038005 2 1 The emergency steering function check is not carried out in the following cases. ! If the starting switch is turned ON, turned OFF again without starting the engine, and is then turned ON again. !
If the starting switch is turned ON again immediately after stopping the engine when the steering oil pressure has not gone down completely. ! When preheating is being carried out. When preheating is being carried out When preheating is being carried out, the emergency steering self- check function is not actuated. To check the emergency steering function, press the emergency steering switch after completing the warming-up operation. WA470-6H – VEAM946100 3-127