Operation 3.5 Cold weather operation 3.5.4 Warming-up operation for steering hydraulic circuit in cold weather If the steering wheel is operated and stopped while the oil tem- perature is low, there may be a time lag before the machine stops turning. In this case, use the safety bar to ensure safety, and perform the warm-up operation in a wide place. Do not load up the hydraulic oil in the circuit continuously for more than 5 seconds. When the temperature is low, do not start the operation of the machine immediately after starting the engine.
GK047005 Free Lock Warming up steering hydraulic circuit Slowly operate the steering wheel to the left and right to warm up the oil in the steering valve. Repeat this operation for about 10 minutes to warm up the oil. NOTE Unlock the safety bar. Operate the steering wheel a little and stop in that position. Then, confirm that the machine is steered by an angle equivalent to the turning angle of the steering wheel. WA470-6H – VEAM946100 3-159 WARNING WARNING