3.6 Long-term storage Operation 3.6 Long-term storage 3.6.1 Before storage When putting the machine in storage for a long time, do as fol- lows. ! Clean and wash all parts, then store the machine indoors. If the machine has to be stored outdoors, select level ground and cover the machine with a sheet. ! Fill the fuel tank to prevent moisture from accumulating. ! Completely fill the fuel tank, lubricate and change the oil before storage. ! Apply a thin coat of grease to the metal surface of the hydraulic piston rods. ! Disconnect the negative terminals of the battery and cover it or remove it from the machine and store it separately. !
Make sure that the machine does not move by setting the safety lock lever in the LOCK position. ! To prevent corrosion, be sure to fill the cooling system with Supercoolant (AF-NAC) or permanent type antifreeze (den- sity between 30% and 68%). 3.6.2 During storage If it is unavoidably necessary to carry out the rust-preventive operation while the machine is indoors, open the doors and win- dows to improve ventilation and prevent gas poisoning. ! During storage, always operate the machine once a month so that a new film of oil will be coated over movable parts and component surfaces. At the same time, also charge the battery. !
When operating the work equipment, wipe off all the grease from the hydraulic cylinder rod. ! If the machine is equipped with an air conditioner, operate it for 3 to 5 minutes once a month to lubricate each portion of its compressor. Be sure to idle the engine at low speed for this purpose. Also, check the quantity of refrigerant twice a year. 3-160 WA470-6H – VEAM946100 WARNING WARNING