4.2 Outlines of service Handling oil, fuel, coolant, grease and carrying out KOWA (KOMATSU Oil Wear Analysis) Maintenance Grease ! Grease is used to prevent twisting and noise at the joints. ! This construction equipment is used under heavy-duty con- ditions. Always use the recommended grease and follow the change intervals and recommended ambient temperatures given in this Operation and Maintenance Manual. ! The nipples not included in the maintenance section are nip- ples for overhaul, so they do not need grease. When using the machine after it has been in storage for a long time, carry out greasing if there is any stiffness or screeching. !
Always wipe off all of the old grease that is pushed out when greasing. Be particularly careful to wipe off the old grease in places where sand or dirt sticking in the grease would cause wear of the rotating parts. Carrying out KOWA (KOMATSU Oil Wear Analysis) KOWA is a maintenance service that makes it possible to pre- vent machine failures and downtime. With KOWA, the oil is peri- odically sampled and analyzed. This enables early detection of wear of the machine drive parts and other abnormalities. We strongly recommend you to use this service.
The oil analysis is carried out at actual cost, so the cost is low, and the results of the analysis are reported together with recommendations which will reduce repair costs and machine downtime. Periodic use of KOWA makes the following possible: ! It enables abnormalities to be detected early, leading to reduction of repair costs and machine downtime. ! It enables repair schedules to be planned, leading to improved machine availability. 4-10 WA470-6H – VEAM946100