4.9 Service procedure Maintenance Initial 50 hours service (only after the first 50 hours) 4.9 Service procedure 4.9.1 Initial 50 hours service (only after the first 50 hours) Carry out the following maintenance only after the first 50 hours. Check for loose wheel hub bolts, tighten If wheel hub nuts (1) are loose, tire wear will be increased and may cause accidents. 1. Check for loose nuts, and tighten if necessary. When checking for loose nuts, always turn the nuts in the direction of tightening to check. Tightening torque: 927 ± 103 Nm 2. If any stud bolt is broken, replace all the stud bolts for that wheel.
4.9.2 Initial 250 hours service (only after the first 250 hours) Carry out the following maintenance only after the first 250 hours. Replace transmission oil filter cartridge For details see "Change oil in transmission case and transmis- sion oil filter cartridge, clean strainer (4-74)". Replace hydraulic tank filter element For details see "Change oil in hydraulic tank, replace hydraulic filter element (4-77)". 4.9.3 Initial 1000 hours service (only after the first 1000 hours) Carry out the following maintenance only after the first 1000 hours. Check engine valve clearance, adjust For details see "Check alternator (4-85)". WA470-6H – VEAM946100 4-31 1 GK032274