Komatsu — Clean, replace air cleaner element

4.9 Service procedure Maintenance When required 4. Clean the interior of the air cleaner body, cover (3) and evac- uator valve (6). NOTE The inner element must not be used again even after its clean- ing. When replacing the inner element, replace the outer ele- ment at the same time. 5. Direct dry compressed air (Max. 0.69 MPa) from the inside of the outer element along its folds. Then direct the com- pressed air from the outside along the folds, and again from the inside. GK032241 6. If small holes or thinner parts are found on the element when it is checked by shining a light through it after cleaning, replace the element.

NOTE When cleaning the element, do not hit or beat it against any- thing. Do not use an element whose folds, gasket or seal are dam- aged. GK032242 When installing the cover (3), check O-ring (7) and replace it if there are any scratches or damage. 7. Set the cleaned outer element in position, then secure cover (3) with mounting clips (2). 8. Press the button of dust indicator to return the yellow piston to its original position. 9. Close the engine side cover on the right side of the machine. After cleaning, if the air cleaner clogging caution lamp lights up immediately or the yellow piston reaches the red line (7.5 kPa), replace the inner and outer elements.

GK043050 WA470-6H – VEAM946100 4-33 3 7 6 GK032240 CAUTION