4.9 Service procedure Every 250 hours service Maintenance When it is impossible to check electrolyte level from side of battery If it is impossible to check the electrolyte level from the side of the battery, or there is no display of the UPPER LEVEL line on the side of the battery, check as follows. 1. Open the cover of the battery box. There are two battery boxes: One on each side at the rear of the machine. 2. Remove cap (1) at the top of the battery, look through the water filler port, and check the electrolyte surface. If the electrolyte does not reach the sleeve, add distilled water so that the level reaches the bottom of the sleeve (MAXIMUM) (UPPER LEVEL line) without fail. 3.
If distilled water has been added to any cell of cap (1), add distilled water also to the other cells. GK043081 1 Use the diagram below for reference, and check if the electrolyte reaches the bottom of the sleeve. Filter port Sleeve Upper Lower A B 4. After adding distilled water, tighten cap (1) securely. GK032270 REMARK If distilled water is added to above the bottom of the sleeve, use a syringe to lower the level to the bottom of the sleeve. Neutral- ize the removed fluid with baking soda (sodium bicarbonate), then flush it away with a large amount of water or consult your KOMATSU distributor or battery maker.
When it is possible to use indicator to check electrolyte level If it is possible to use an indicator to check the electrolyte level, follow the instructions given. 4-60 WA470-6H – VEAM946100 A Correct level The electrolyte level is up to the bottom of the sleeve, so the surface tension causes the surface to rise and the plate appears to be warped. B Too low (level) The electrolyte level is not up to the bottom of the sleeve, so the plate appears to be normal.