Komatsu — Change oil in hydraulic tank, replace hydraulic filter element

4.9 Service procedure Every 2000 hours service Maintenance 9. Remove mounting bolts (8) of filter cover (7) at the top of the tank, then remove the cover. 8 When the cover is removed, the force of spring (9) may make the cover fly off, so keep the cover pushed down when removing the bolts. 7 9 10 10. Remove spring (9) and bypass valve (10), then remove ele- ment (11). 11 11. Check that there is no foreign material inside the tank, then clean it. 12. Install new element (11), then set bypass valve (10), spring (9), and cover (7) to the tank. GK047054 If the O-ring of the cover is damaged or deteriorated, replace it. 13. Remove 6 bolts (13), then remove cover (12). 13 14 14.

Pull the top of rod (14) from the top and remove strainer (15). 15. Remove any dirt stuck to strainer (15), then wash it in flush- ing oil. If strainer (15) is damaged, replace it with a new part. 12 16. When installing the cover bolts, push down the cover and tighten the bolts evenly. 15 17. Add engine oil through oil filler port (F) to the specified level, then install cap (F). 18. Check that the hydraulic oil is at the specified level. For details, see "Check oil level in hydraulic tank, add oil (4-56)". 19. Run the engine at low idling, and extend and retract the steering, bucket, and lift arm cylinders 4 to 5 times.

Be care- ful not to operate the cylinder to the end of its stroke (stop approx.100 mm before the end of stroke). GK047055 NOTE If the engine is run immediately at high speed or the cylinder is operated to the end of its stroke, the air inside the cylinder will cause damage to the piston packing. 4-78 WA470-6H – VEAM946100