mercedes-benz — Mercedes-Benz of North America, Inc. Service Manual 1993

conrod Matching conrod bearings and installing conrod and check angles of bearing bores relative to each other 15 Recondition (03313). conrod bearing cover with bearing shell and tighten 16 Insert conrod bearing shells. Install conrod bolts to an initial torque of 30 Nm and angle of rotation torque of 90”. Note Conrod bearing shells are supplied only in the yellow version. 17 Measure bearing diameter and note. conrod bearings. 18 Measure wrist pins, determine radial play of Note If the conrod bearing play exceeds the specified value, dress mating face of conrod bearing cover on a surface plate to max. 0.02 mm. conrod and install (03-316).

Note The 19 Fit pistons to conrod must be installed on the pistons so that the chamfered splash bore in the small end bearing (arrow) and the arrow in the piston crown are facing the direction of travel. 03.0905 - 320113