Removal and installation Note Before replacing the front crankshaft radial seal, it is necessary to determine whether the leak is occurring at the timing case cover itself (shrink holes, cracks). This is done by cleaning the bottom area of the timing case cover free of oil, drying and spraying it with “MB contrast spray white”, Part No. 009 989 03 59. Run engine and pin- point oil leak after 2 - 5 minutes. 1 Pry radial seal (45) out of the timing case cover with a screwdriver. When performing the step, ensure that the crankshaft journal and the mounting hole in the timing case are not damaged. Cover over crank- shaft journal with a rag. Deburr mounting hole, if necessary. 03.0905 . 32414