mercedes-benz — Mercedes-Benz of North America, Inc. Service Manual 1993

Checking 1 Position camshaft on the hydraulic element under test so that the rocker arms contact the cam base circle. 2 Press on the rocker arm with a hammer butt or similar above the hydraulic valve clearance compensating element for 5 - 10 seconds. If one compensating element drops noticeably compared to others, compensating element should be removed. To do this, remove rocker arm bearing support (05235) and press the compensating element (58) together with the washer carefully out of the rocker arm with an aluminium or brass mandrel. If a leaking compensating element cannot be detected, try to move the rocker arm by hand.

If play is detected when doing this, check and correct fitting position of the hydraulic valve clearance compensating elements (05-214). Caution! When testing compensating elements, do not press valves against the piston crown. 3 Fill reservoir chamber of the hydraulic valve clearance compensating element with engine oil, carefully press on ball valve in the setbolt with a wire (approx. 1.5 mm setbolt downwards as far as the stop and release. Repeat process two or three times. (21) and press PO5- 2011-13 05.0906 - 21116