- 10 seconds with hammer butt or similar. If the After this, press compensating element setbolt heavily downwards for about 5 setbolt drops noticeably when doing this, replace the compen- sating element. Note Compensating element must be vertical when filling the working chamber as well as during the test. If compensating element does not drop noticeably, check the respective oil bore in the cylinder head (arrow) as well as the oil bores in the rocker shaft and in the rocker arm for free passage, and clean if required. To do this remove rocker arm (05240).
If several compensating elements are loud or soft the oil nozzle in the cylinder head should be checked for firm seating and replaced if required. Replacement 51 4 Slide new valve clearance compensating element (58) with the original washer (57) into the rocker arm (51) as far as the stop on the snap ring (56). Note Install new compensating element with the working chamber and reservoir chamber filled with oil. (See Figure 3 for filling the hydraulic valve clearance compensating element). The grooves in the washer (57) must point to the compensating element (58) (Figure 5). I 56 PO5-2012-13 05.0906 - 21117