mercedes-benz — Mercedes-Benz of North America, Inc. Service Manual 1993

Corrections 5 Remove rocker arm bearing support (05235). 6 Press hydraulic valve clearance compens- ating element (58), together with the washer (57), carefully out of the rocker arm with an aluminum or brass mandrel, and finally slide into the rocker arm up to the snap ring stop (56) again. Use a thinner washer (residual stroke too small) or a thicker washer (residual stroke too large). POS-2012-13 If specified residual stroke cannot be achieved with the washers available (57), depending on residual stroke measured, use a thinner or thicker ball socket (55) (see note, on the washer and ball socket tables). Caution!

Before carrying out the installation fill reservoir chamber of the hydraulic valve clearance com- pensating element with engine oil (05- 211, Number 3). The grooves in the washer (57) must point in the direction of the compensating element POS-20 setbolt. 7 Install rocker arm bearing support (05-235). 8 Repeat tests, Numbers 1 to 3. Note Before carrying out the test turn the crankshaft a few times by using the starter. 9 The installation is carried out in the reverse sequence of the removal. 10 Check for leaks when engine is running. 05.0906 - 214/8