mercedes-benz — Mercedes-Benz of North America, Inc. Service Manual 1993

Only rocker arm bearing supports where camshaft bearing half bore is 0.05 mm larger than on production parts are supplied as spare parts. This prevents the camshaft binding when replacing a bearing support. In the event of bearing seizure or pronounced striation the camshaft bearings can be bored out by 0.5 mm and a camshaft with oversized journals installed (01-419). These camshafts have different code numbers (05215 and 05-220). If the bearing supports are put together without rocker shafts, tighten the set bolts to max. 15 Nm, otherwise the shaft bores distort.

The radius on the rocker arm has been changed in order to increase the clearance between the rocker arm and the valve spring retainer (arrow). 05 0906 - 24013